This 1 lb. rubber mallet is the ideal tool to press t-molding into place without damaging it!

This all purpose tool pouch is designed for the Ronan 301 multi cutter but can fit a variety of other tools as well. Use the belt-loop or the metal belt-clip on the back to attach it to your belt.

This trimmer can be used to trim t-molding to be flush to the end of the wood after it is installed. Good for t-molding up to 1" wide.

This cutter can be used for other soft materials like rubber extrusions, wood screen moldings, plastic hose and others.

Replacement anvil and 3 blades for the Ronan Multi-Cut models 300, 301 and 330.

This notch cutter cuts a notch 1/4" wide, flush up to the inside face of the molding, allowing the molding to easily go around tight corners.

Quad Trimmer with carbon steel blades for trimming edgebanding and t-molding. With a comfortable and ergonomic design, it trims both sides of the trim in 1 pass, or pull it apart and use half the trimmer to trim just 1 side.

Trimmer with replaceable steel blade for trimming edgebanding and t-molding. Blade can be angled from 0 to 45 degrees.

Replacement blade for the Radzi Edge Trimmer

The SpeedRoller PRO is an ergonomic laminate roller that can be used to easily install peel and stick edgebanding. The SpeedRoller includes 2 sets of interchangeable wheels.

Use with T-Molding that has a 7/64" wide spine (including the barbs).

Requires a slot cutting arbor, such as the A200B or equivalent.

Use with T-Molding that has a 3/32" wide spine (including the barbs).

Requires a slot cutting arbor, such as the A200B or equivalent.

Use with T-Molding that has a 11/64" or 3/16" wide spine (including the barbs).

Requires a slot cutting arbor, such as the A200B or equivalent.

Use with our LED T-Molding housing or any T-Molding that has a 1/8" wide spine (including the barbs).

Requires a slot cutting arbor, such as the A200B or equivalent.

For use with all of our slot cutter router bits, for routers that use 1/2" shanks.

For use with all of our slot cutter router bits, for routers that use 1/4" shanks.

Replacement blade for the t-molding Notch Cutter

For use with all of our slot cutter router bits, for routers that use 1/2" shanks and you need to cut farther into the wood.